![]() I have a 1000W bike with the SW900 screen and that is more what she wants. It is a colored screen that is almost impossible to see in the sun. One more reason for changing controllers is that she hates the screen. The new controller does say dual mode for speed set. I will have to review all the custom settings on this new controller see if I can find something that allows me to turn down the overall power of the controller maybe that will help PAS speed. As far as it being a sinewave or square wave I really don't know manufacturer couldn't tell me but as I understand it I can switch over to a sinewave and it will be better than the square wave. I know they do sell KT controllers with the new waterproof harness is I just haven't found any they have the 3 pin battery and the 9 pin 1 to 5 wire harness connector. Finding KT controller or other that actually works with them. ![]() Problem I'm having is finding one that is compatible with the one to five wire harness.Ĭlick to expand.I'm not overly concerned with battery connectors more concerned with the Juliette connectors. Right now I'm leaning towards a KT controller with the LCD3 screen. I need to find a controller that I can set what the PAS is to slow it down. She also rides it on PAS and it goes 13 miles an hour. it is not consistent at all, on regular start it wants to knock you off the back of the bike it takes off so hard. 2) Anyone know the pinout I can find 8 pin female julet connectors on Aliexpress but I can't find male ones or an extension cable. Two questions: 1) Anyone know where to buy an extension cable I see lots for Bafang (9-pin) but none for the 8 pin Das-Kit connector. So now I have the new controller ( DC moto controller by lithium battery 25A 1-4.2 Volt dual mode) and it works but my wife absolutely hates it. The C7 has a Julet connector that looks to be 8pin. So if push came to shove, I could put my original hardware all back on and go to the original individual plugs. I didn't put up much of a fight because I really did like the idea of switching from all the individual wires to this one nice waterproof harness. ![]() The controller that came with this bike (DMHC 18A) went bad so I contacted the manufacture in China and bought a replacement controller but also had to switch to the waterproof one to five wire harness that forced me to change out the brake handles, throttle, light. 1 to 5 wire harness the 5th wire is for the light but also as it seams makes getting a controller with the 9 pin plug instead of the 8 more difficult.bafang 750 watt gear hub with the 3 wire plug.I'll start off with what I have and then I'll go into what my issue is maybe somebody can give me a good recommendation for my wifes bike. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |